AdventurAir

Expanding Frontiers

The Adventurair can do it all - windsurf, white water paddling, fishing and touring. The Scotty mounts for fishing rods, the mast plug for windsurfing, the wide array of bungee straps, D-rings and handles, Adventurair has it all! The quad setup with four 3” short soft fins is there for those shallow river pockets or white water action. You can add the middle fin for added traction and a center fin for better upwind performance while windsurfing. The Tail Rail Edge enhances the performance of the boards by allowing a quick water release.

The AdventurAir comes with 1x 9″ fin, 1x 10″ fin, 1x Double Action Pump and 1x Adventure Edition Roller Bag.

+ more + close

Specifications Technologies

cm / inch

SE 3DS

12'0"

12'0"
Length (cm)(in): 36612'0"
Width (cm)(in): 9136"
Volume (l): 405
Weight (kg)(lbs): 13,5 29,7
+/- 10%
Thickness (cm)(in): 15,26"
Fin: 9" + 10" center fin + 4x 3" fixed fins
Fin box: 2x US compatible
Windsurf Mast Plug: Yes

SE 3DS

Rail

The outside rail layer is glued over the first layer for added stiffness and abrasion resistance.

Triple Layer Composite Drop Stitch
The 2 PVC layers make sure your JP Inflatable is 100% airtight, and the Polyester 1000D fabric in between them creates a super durable composite stretch-resistant structure.

Inner Rail

The first rail layer is welded to the DS fabric to ensure a long-lasting mechanical bond.

3D Stringer
The 3D stringer is the most innovative solution to increase the stiffness of an inflatable board. It connects the deck, rail and bottom into one strong and solid U-beam. This has increased the stiffness of the boards up to 30%. Furthermore, the 3D Stringer increased the glued overlap surface in the high high-stress standing area, increasing the safety of the boards.

Welded Seam Technology

JP-Australia developed the Welded Seam Technology to increase the durability and airtightness of our inflatable boards. The connection between the rail and the drop stitch material is hot-air welded thus creating a very strong mechanical joint that turns these two parts into one. By fusing two different layers together into one part, the welding process makes the board safer and more durable. The plasticizers in PVC migrate over time and weaken the strength of the chemical bond of the glue.

Pre-Lamination

Our Triple Layer Composite and our Double Layer constructions both include the specially developed process of pre-lamination. This high-tech process consists of machine-lamination of the multiple layers into a shell that has accurate thickness as well as superior abrasion and stretch properties. Compared to normal double layer boards we have been able to remove the manual glue application from the process and with it the room for error, the excess weight of the glue and the additional health hazards for our workers. The fiber-reinforced layers create super strong and durable boards with a minimal amount of stretch.

The 3 pre-laminated composite layers consist of 2 airtight PVC sheets bonded to a Polyester 1000D fabric to create one super strong shell. This shell is then machine laminated directly onto the 500D Polyester Drop Stitch fabric. The pre-lamination and the composite structure create an unprecedented weight/stiffness/durability ratio ever produced in an inflatable SUP. The SE 3DS boards are offered in 6” thickness, with the exception of the SurfAir 9’7”x32” (4” thick).

You are currently viewing a placeholder content from Youtube. To access the actual content, click the button below. Please note that doing so will share data with third-party providers.

More Information

Accept required service and unblock content